Chosen Solution
Would any one have a link to a video or instructions on how to remove a charing/sync port from an ipod classic motherboard? All the links I am able to find show how to solder a new port back on, but skip over the part where they are removing the defective one. Is it possible to remove the port without damaging it? What kind of a tool is needed to separate the pins from the board?
@krams the connector is soldered to the board. Check this video for more information. Yes it is possible but you need to have the right tools and skills. You’ll need plenty of flux, solder wick and a steady hand with good eyesight. Usually one does not care about damaging the connector since the only reason to take it off is to replace it with a new one anyway. I use a hot-air rework station to remove it which habitually melts the connector ;-)
