Chosen Solution with the power cord plugged in the light around the plug doesnt come and the laptop doesnt come on ok..here it goes for the whole world.. The problem was that PQ1 was bad. Is located next to the PCN1 “where the power jack connects to the motherboard next to the memory”. PQ1 is a P-Channel PowerTrench MOSFET P#: FDS6675BZ. you have to replaced it and the problem has to be solved....
Chosen Solution A friend recently came to me with a broken Xbox 360 S, he experienced a lot of hiccups and freezes, after a couple of days the Xbox gone red. So i took a look at it and i got an E14/0032 error. Which means it might be temp sensor related. So i took a look at some options, the first one was an reflow, unfortunately i don’t have such equipment or a store nearby to do that....
Chosen Solution I know that this is listed under backbeat fit but I didn’t see the option to choose the backbeat go 3 which is what I am having difficulties with. It will still charge and when I connect it to the charger, it shows that it has a full battery. No buttons are stuck, and I know that it hasn’t been exposed to any type of water damage. When I try to hold the power button to turn it on, the headphones simply won’t turn on....
Chosen Solution When I plug in my charger my device doesn’t start charging Check your charger to make sure that It is properly plugged in, if it is. You may have a faulty battery that will need replacing.
Chosen Solution Problem solved folks. I use a hidden network and don’t have SSID broadcast turned on. Apparently the Alexa app cannot connect to hidden networks. You have to broadcast the SSID during setup, and can hide it again once you’re connected. However, if your connection drops for any reason, the Echo will no longer be able to connect.
Chosen Solution I cannot get the laptop to boot in normal windows or safe mode. In normal boot it stays at the windows logo and kinda pulses. In safe mode it gets to where it appears it is trying to boot with a horizontal line like it is loading. I’ve tried repair and have not been able to get into the hidden directory that has the factory back up. Suggestions? Sailor...
Chosen Solution Got the console from someone who claimed the unit would work and then freeze up after a few minutes. He needed the original power supply for his replacement console, so I bought one to use for myself. One plug tested at 5V. The other tested at 12V. I don’t remember measuring current. The console AC adapter was plugged into a surge protector sharing a TV, an HDTV antenna receiver, and a laptop AC adapter....
Chosen Solution I recently opend up my xbox one to clean it to stop over heating while doing this i broke the wifi module antenna cable since then my controller will not contect properly i now have to use a micro usb to use my contoller does any one know of a way to fix this problem or where i can get another wifi modlue antenna cable thank you. Same, thinking of next generation
Chosen Solution Health dangers of 2.4GHz https://ehtrust.org/science/peer-reviewe… Is it possible to disable or remove the Xbox One S wifi / RF module and have the console play games fine using a third party wired controller without blanketing users in bluetooth or wifi? In other words, zero bluetooth being emitted by the console along with zero chance of wifi being activated. 100% wired. Anyone done this? you can remove the wifi card and something called an IR blaster....
Chosen Solution So I was trying to reset the display connectors because I had the common problem of LCD screen going dark. But when I removed the back case panel, and had to remove the connector for the mode settings, which is attached to get the entire back cover off, instead of just sliding it up and out, I yanked off the entire housing. Is it ruined now? There seems to be no way to just pop it back into place....
Chosen Solution I haven’t used my old Gear watch after buying my Gear 2 - now when I try to charge it, nothing is happening. I’ve tried connecting to my computer (as some forums say that works) and still no luck. I let it trickle charge all day with no signs of life :( I’m going to get swapping batteries and see if that works. connect your galaxy gear to a computer and allow the USB to trickle charge until the charging symbol appears, this can take am hour or so, so be patient, once the charging symbol appears you’ll then be able to charge it from the mains supply....
Chosen Solution Started working on my truck a month the ago with the mind set of a rear main seal and clutch assembly job. Ended up getting the wrong fly wheel and burnt up a starter and relay. Bought both including exchanging for a smaller flywheel and replaced them. I can charge the battery and it won’t start unless set above 12 volts. It’ll idle fine but after I turn the truck off I can’t get it to turn over....
Chosen Solution washer will not agitate or spin, drainage filters and hoses r not clogged. what else could it be Cause 1 Motor Coupling The motor coupling connects the motor to the washer transmission. If the washer is overloaded, the motor coupling will fail in order to protect both the motor and transmission. The motor coupling can also fail due to normal wear. Inspect the motor coupling to determine if it is broken....
Chosen Solution my workforce will not power up after a power outage. it has a fuse on the main board that seems to blow easily , if it’s completely dead that’s probably it , a factory repair costs more than a new printer, don’t use the cleaning cycle on these more than once it uses a lot of ink and then clogs the nozzles worse than before There is no fuse on the main board
Chosen Solution Is there still an issue with replacing the screen on the iPhone 8/8+ bricking the phone? Or have the more recent ios updates fixed this issue. I havent had the issue since they patched the original issue.
Chosen Solution Just did a straight swap of my logic board(820-3330-B) and it doesn’t recognize drive. Repaired with DU, with no results. Logic board swap out: As you are running Catania your drive is running APFS. So a common issue is the replacement logic boards firmware is still the older version so it doesn’t know how to boot up under the newer macOS. I would use a bootable OS installer USB thumb drive to re-install the OS so the installer updates the systems firmware....
Chosen Solution So bought the new M1 chip MacBook Pro thinking it would give me 20 hrs of battery run time. But a week ago I spilled black coffee over it (maybe 30 ml) and so I let it dry for a day and next day I turned it but I faced a problem where it wont turn on just on battery itself but it would turn on when I plug in the power cord....
Chosen Solution After the original battery reached about 20 minutes of capacity and began to swell, I ordered a replacement from ifixit. I was impressed with everything and the battery installation was easy. While connected to the dock, occasionally the front light will flash amber four times and I will get a notice to plug in my laptop, that the battery is 0%. Then it will go away. I reinstalled my original battery and it worked fine, despite not having any capacity....
Chosen Solution So earlier, my phone had gotten a little damp from the rain (water getting in my pocket) on the screen. Nothing bad happened to it, it’s just when I woke up, it kept turning on and off. It would go halfway through the startup screen, then the AT&T screen, and then it would stop and go back again. I took the battery out, didn’t work. Taking the AT&T card out itself didn’t work....
Chosen Solution I have a 99 Honda accord. It won’t start, but it makes noise like it’s starting. The key also keeps getting stuck in the ignition and when I looked under the hood it was leaking, but I don’t know what it is or where it’s coming from. Make sure your car shifter is correctly positioned on park or neutral. If it’s not, that might prevent you from removing the key from the ignition....
