Chosen Solution My PS3 does not eject discs. When you put in a disc, it accepts them, but very slowly. Then, it won’t eject them. Also, and this could be key information, the manual eject feature (where you pull off that tab on the bottom of the console where the blue screw is, then insert a screwdriver in the hole and turn counterclockwise to slowly eject the disc) will not work either....
Chosen Solution When I try to take pictures, the flash will not go off when I want it to. The flash may be turned off on the camera. Press the circular button surrounding the “FUNC. SET” button to the right turns the flash on and off. The bulb also may be burned out, causing the flash not to work. The flash bulb may be replaced but if the entire flash assembly has been damaged you will need to replace the entire flash assembly....
Chosen Solution so i dropped my phone in the water , half of it, it covered charger hole and earphone hole for a second, i immediately took it out and dried right away in vertical position so the water would not go to inside. everythign works perfectly , other than I cant hear anythign when i plug int he earphones. is it possible that it recovers on its own? Should i leave my phone in vertical position so if any water is left , it wont damage the rest of the phone?...
Chosen Solution My windshield wipers only work on high speed and my washer pump don’t work 2003 Crown victoria @n1967 , Napoleon, The wiper switch in the multifunction switch which grounds the input wires in different combinations to signal the wiper motor, telling wiper motor which speed/function has been requested. The electronics are all built into the wiper motor. You may have a bad/corroded wire/plug, faulty multi function switch or bad wiper motor....
Chosen Solution I’ve got a Black 2.4 GHz A1181 MacBook. Its bezel, keyboard and battery had been previously replaced. It’s been left a few years in a drawer and now doesn’t turn on at all! Battery doesn’t charge, light at the front doesn’t light up and the fan does not spin at all. When mains is plugged in the charger LED goes from Green to Amber meaning that its trying to charge the battery, but it doesn’t....
Chosen Solution When I plug my tablet into my computer with the USB cable, my computer doesn’t seem to recognize the device. What are possible causes for this and how can I solve it? The problem you are having could be due to a number of reasons such as a faulty USB port, cable, or Micro USB board or un-updated software. Please visit the Nexus 7 (2nd gen) troubleshooting page for possible solutions to your problem....
Chosen Solution When I plug my laptop in to charge I occasionally get a green light for a split second, then nothing. I took it into Apple and they said it was the IO board but it has water damage so they won’t repair it. I replaced the IO board and still get the same issue. It was working perfectly until the battery ran out. Any ideas? IF the battery is bad it will not charge go to setting find battery they may tell you to replace battery....
Chosen Solution Why did my window fall down when I slammed the door and won’t go back up on my 2004 quad cab front door It has most probably come off the bracket and or the window winder rail you will have to remove the door panel so you will have access to the rail system and put the window back in the correct place on the railing or it could be (less likely) that the railing bracket has broken somewhere and if so the railing system will need to be replaced or fixed if possible....
Chosen Solution I opened up my gun to replace the firing spring but now the gun won’t fire. I loaded the gun and pulled the trigger and nothing happened there are no jams too. I think that you might’ve lost a part in your gun or just that a bullet is jammed in your gun.
Chosen Solution I don’t know if this is the right platform to ask for help on this but I’ll try anyway. So recently a sibling accidentally took off the “W” key from my laptop. I followed youtube tutorials on taking out the 2 plastic pieces that surround the rubbery circle below the key and I removed them without damaging them. After that I noticed there it was a little dirty under the key so I cleaned most of the dirt out....
Chosen Solution why wont my instrument panel lights turn on Assuming there’s not a problem with the on switch itself (I would check that first), It’s possible the bulb has simply burnt out. I have never personally replaced a panel bulb myself but ChrisFix on youtube does a wonderful and easy guide to replacing them. Here is a link to a video you might find helpful: https://www.youtube.com/watch?v=qRMSvFO7… If you’re referring to the center console, the process may be a bit different....
Chosen Solution My iPhone 5s won’t turn on . But when it did I had to keep it on the charger . If I took it off it will turn off . Even restarting my phone won’t work . sometimes the apple logo will appear , then disappear . Can i get a solution please Pode ser problema no home buton , bateria e etc
Chosen Solution my phone has had no replacements over its use and all of a sudden the call quality has just gotten worse and worse. now the phone is stuck on searching no matter what I do to it. i have tried using a new sim card as well but that didn’t work either. Has the phone ever been badly dropped? Something inside might have damaged the internal antenna. Go into Settings > General > About and check to see if your phone displays a Modem version and IMEI....
Chosen Solution Weirdly, when key is in start position odometer will begin to add miles. Vehicle was parked 5 months ago and ran fine and is in near mint condition with 190,000k km LOL! The odometer is a new one on me. Anyways, battery charger or battery charger with boost capabilities? After sitting for 5 months an older battery can totally lose it’s charge and is a possible indication the battery is on it’s way to where batteries go when they give up the ghost....
Chosen Solution Bravos 300 top-load washer: MVWB300WQ0 After replacing the lidlock, I buttoned everything back up and plugged the washer in. Aha! Regular startup screen. Chose the drain and spin cycle, display showed 14min as usual. Pressed start. Heard the magnetic lidlock engage and the light came on. Cycle never began. I then pushed cancel. After that, any button I push, or turn of the knob , causes a beep. Display no longer showing anything....
Chosen Solution My Xbox One continues to make noise when turned off, how do I determine if its the fan or disc drive. Unit works otherwise concerned about fire. When you turn it off the system goes into a sleep mode that allows it to maintain game progress as well as application data. This in turn will keep the system active for a little while after shutdown. If you don’t want it to persist you can change this in the system settings to do a full shutdown instead....
Chosen Solution Hi there, Lenovo yoga 2 pros have wifi and graphics driver incompatibilities with Windows 10, and Lenovo has not released drivers that fix the issue. I was given a referbished yoga 2 pro with Windows 10 preinstalled, and had the incompatibility issues well documented all over the net. So I decided to do a clean install of windows 8.1 on the laptop. I made the USB with windows media creation tool for windows 8....
Chosen Solution My tablet YXTEL M901 fell down and the screen is broken. Is it possible for the touch screen be replaced. And is it going to work normally again????? GLADYS moi aussi j’ai un téléphone tablette tactile yxtel qui est tombé et l’écrant s’est cassé , je voudrais le remplacer?
Chosen Solution My Z30 have the microphone broken , can i change it? where? I’m speacking of the normal microphone , for example in hearphone we can use it without problem . I suppose there is 2 different microphone. Thanks glf 61 the mic is on its own flex and adhered to the midframe. Use this guide to get there. The mic shows on the picture for step 6 on the bottom of the midframe....
Chosen Solution I have a glass and LCD from iphone 4, My question is, Glue or not glue? LCD on glass. The glass and LCD are fused together. I don’t think that it’s glue, but I could be wrong. If you read this question it should clarify some things. yes glued, you can use a transparent uv glue. not so easy!!! a cheap and simple way is to glue the back of the LCD or use a two sided tape....
