Chosen Solution Shows no life as I put battery into it @michellea first make sure that you have the right batteries. You need two 1.5 to 1.55 volt batteries. Make sure that you have the batteries properly inserted and that the battery connections are not corroded etc. . After that turn the cameras power switch on. If that does not get you any results you will have to dig deeper. the error could be on the flex cable or the PCB....
Chosen Solution i bought an archos 101 without a charger and bought one direct from archos via internet. its been charging over night and still wont start and green light still shows solid… is there anything that can be done to get it turned on? There may be a problem with your charger. Even thought the light is on, it may not be going through the wire into your device. I would try a new charger, or else, check the end of the charger with a powerful multimeter (warning: very high voltages when dealing with this) and if it shows a voltage, the charger should be fine....
Chosen Solution Hi guys! I still have a Macbook 13” 2008 Unibody - works without a problem. I’d like to install Windows 8.1 on it and give at away. So far, I’ve installed it and then ran full Windows Update. The bootcamp exe didnt work (saying this model is not supported), but WinUpdate picked up most of the devices, except the chipset, bluetooth, audio, and for some reason the red light in audiojack socket (SPDIF i guess) is always on....
Chosen Solution So I have this Mac and it’s working kind of. I have noticed that with the LCD connected it won’t boot at all. However with the screen disconnected and using a separate display it boots and works is this an LCD flex issue or panel issues? Or could this be something else ? Any advice is hugely helpful. Well, it does look like the logic board connector got a bit of a tug as the detent tabs are bent as such the connector might not be making good contact with the cable....
Chosen Solution Someone tried to hot wire the car, we put a new ignition in it. We had our local locksmith come program the new key to the car and that works except once you turn the car off it won’t start again unless the locksmith reprograms the key again. I want to say the locksmiths code reader said some module was bad but I can’t remember now. Has anyone experienced this before?...
Chosen Solution I replaced the battery in my MacBook Air with an ifixit kit in July. Turned it on today and the system settings tell me that there is no battery installed. Tried the cmd-shift-option-power reset to no help. As soon as I remove from wall power the computer turns off immediately. Is this a bad battery? From the other answers I’ve seen around with here, it’s most likely you got a bad battery and will have to contact iFixit....
Chosen Solution Hi, I just replaced the battery and charging port for my Iphone 6s and now my screen won’t reconnect. The home button connector fits fine but both screen ones don’t. This is the same screen I had. So it’s the same screen? If it’s an aftermarket screen, it may be an error. If not try checking if the pins on either of the screen or the phone are damaged....
Chosen Solution I would like to be able to establish Wi-Fi-Direct connections with this MacBook Air.The original card does not seem to support this.I figure that this wifi card is compatible with my MacBook Air (early 2014):MacBook Air (Mid 2013-2017) AirPort/Bluetooth BoardDoes this card support Wifi-Direct?If not, does anyone know another compatible card, that supports Wi-Fi-Direct?I don’t care about 802.11ac so much (though it would be nice ;-)), as long as Wi-Fi-Direct is supported....
Chosen Solution after getting the phone wet, I am having issues and facing a WiFi struggle after 3 hours later. it will not connect unless the phone is actually on the router itself. I’m not sure if its because its still wet, or that it actually got damaged completely but i would like to know is there anything i can do to repair this myself, and where the antenna is located and if there is any parts to replace this online or on any stores....
Chosen Solution Is this a model number for Kenmore washer 90 series #3356472? Also will not drain or spin @legs that serial number comes back as a 80 series washer. The problem with your washer sound like it does not drain. Since it does not drain it will also not spin. check the lid switch to make sure that is working properly. After that you will have to check the drain pump and see if that is working and clean of any debris....
Chosen Solution Hi, I was trying to fix my DSi when I accidentally put the battery in backwards/opposite. Now even with it in correctly, it no longer turns on. When I try to charge it, the orange light just blinks. Does anybody know how I can fix this? Hi @caydennguyen Most probably the console didn’t have reverse polarity protection so you’ve likely damaged some components on the motherboard. Here’s an image taken from the ifixit Nintendo DSi Motherboard Replacement guide, that shows where the battery connector attaches to the board....
Chosen Solution No matter what I do, my Balance Board will not power on. I press the power button and it does not light up or turn on. There are three things that could prevent the Wii Balance Board from turning on: The batteries are dead. If it’s been a while or you have never changed the batteries in your balance board, then they may need replacing. The battery terminals are corroded....
Chosen Solution My blender will turn on. The blender is not getting any power.The ligths won’t come on and the bender does not work. How do I fix the problem? Mine just stopped working recently. Looks the the circuit board had some damaged components. Not sure if it’s repairable. Mine had the same problem. I replaced one resistor and now it works perfectly.
Chosen Solution My crv was running fine then as we were going up a hill it died on us i replaced the battery spark plugs distributor cap and the main relay now it trys to start but wont its getting gas and i checked the timing one of them is slightly off could that be the problem Has the timing belt been replaced yet? They should be changed every 100,000 miles....
Chosen Solution Someone stole my iPhone last week, I got it back but everything on it was gone all my pics, I can’t log back into my iCloud without my SIM card which is what the still have, but I took it into get repaired considering it wouldn’t charge turns out someone took it apart and left a bunch of missing screws.. Why would they do that? What did they want on my phone?...
Chosen Solution I bought this mac for 50 bucks thinking it would be an easy fix. I bought a new flex cable and installed it since the keyboard and trackpad did not work. When I replaced it the battery now died and I can only use the mac while charging. the battery is damaged and does need to be replaced but will it fix the trackpad and keyboard Do the keyboard and trackpad work with the new trackpad flex cable installed (you can test this by powering on the machine with a charger connected and the battery disconnected)?...
Chosen Solution We have a 2006 Hummer H3 that the windshield molding has seperated from the top rail molding. How to move the top rail molding forward about 1/8” so the front screw will fit back in the molding. That area has broken, it looks like the molding on both sides has moved back about 1/8” and can’t reconnect the windshield molding back to it. Hi, Don’t know the answer but according to the 2006-09 Hummer H3 – Fixed and Moveable Windows section of the repair manual for your vehicle: “The windshield reveal molding is an applied molding design separate from the window....
Chosen Solution I have tried all the tricks and it will not display on external monitor. Its booting up its working but nooo it won’t behave with display. What model/make external display is it? Are you connecting via VGA or other?
Chosen Solution I have been receiving errors in some directions, such as streets on opposite side of town interspersed with correct directions. You may need to check the firmware & map data to see if you can reload it as it might be corrupted. You also want to check to see if it’s compass and/or GPS is off.
Chosen Solution it wont charge the battery, and it is not the battery thats the problem. when i connect it to power it wont turn on and it justs blinks repeatedly for a short while and then stops? Whats wrong with it? i bought it refurbrished. Status LED Description Green (blinks slowly) Charging normally Off Charging finished Green (blinks quickly) Error I would suggest to use a AC charger and not the USB from a computer....
